Mitsubishi Electric CRHV-P600YA-HPB, Service Handbook

Page: 111 / 170

[
VIII
Test Run Mode ]
- 104 -
HWE1312A GB
(10) Check that the unit is operating properly according to the temperature adjustment function.
When a pull-down operation is completed, check that the hot water temperature adjustment function will come on and that the
unit will automatically go on and off. Make sure the ON/OFF cycle (beginning of an operation until the next) is at least 10 min-
utes. (The unit features an anti-short-cycling protection.)
Notes on temperature adjustment function
The water temperature can be controlled based on the inlet or the outlet temperature sensor reading. Select one to use. Refer
to "VII [1]1.Factory Switch Settings (Dip switch settings table)(page 69) and "(1)Setting procedures"(page 73) for how to select
the water temperature control method and how to set the water temperature.
(11) Connect the pump-interlock wire to the appropriate contacts.
1) Connecting the pump-interlock wire
Connect the pump-interlock wire to the pump-interlock circuit (Terminal block and ). The unit will not operate unless this
circuit is complete.
2) Notes on connecting the pump-interlock wire
 Connect an NO relay (solenoid switch) for the pump.
 This circuit is a low-voltage circuit. Keep the pump-interlock wire at least 5 cm away from any wire that carries a voltage of
100 V or above to avoid damage to the circuit board.
(12) Checking the rotation direction of the pump
Check that the circulating water pump is rotating in the correct direction. If the pump is rotating in the wrong direction,
disconnect the pump wiring from the solenoid switch, and reconnect them so that the pump will rotate in the correct direction.
Do not disconnect the power wire to the compressor in an attempt to keep the compressor from going into operation
during test run. (If it is done, the control board will not sense that the compressor is stopped, and the water temperature
will not be controlled properly and the unit may come to an abnormal stop.)
11 12
MP1
51P1
52P1
52P1
51P1
71
72
73
3
5
7
1
70
PL pump fault
52P2
51P2
Recommended pump circuit
F
L1 L2 L3 N
Control board on the unit
Control box on the unit
11
12
52P1
52P2
M
3
MP2
51P2
52P2
M
3