15
8
8.1.2
<A>
<C, D>
<B>
A
A
A
B
*
C
D
[Fig. 8.1.2.3]
<A> Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<B> Run the panel heater wirings between the right rear pillar and the heat exchanger.
<C> Attach the rubber sheet to the right frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a reference
position)
<D> Pull the wiring through the hole on the right frame and into the inner side of the
heat exchanger.
A
Panel heater wiring
B
Right rear pillar
C
Right frame
D
Plate rubber XL
E
Wire seal
* If the frame is not painted, place the supplied wire seal
around the hole
.
Hole
Tab
E
XL-module
Right side
<A>
A
B
[Fig. 8.1.2.4]
<A> Screw down the metal sheet wiring cover at three points.
A
Cover wiring 1
B
Cover wiring 3
WT08867X01.book 15 ページ ２０１８年１月２２日 月曜日 午後３時１７分
