12
8
8.1.1
<C, D>
*
C
D
A
A
A
B
<B>
<A>
L/XL-module
<A> Pull up the panel heater wirings so that the wirings run along the left rear pillar.
<B> Thread the panel heater wirings through the long hole on the left rear pillar.
<C> Attach the rubber sheet to the left frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a reference
position)
<D> Pull the wiring through the hole on the left frame and bring it into the inner side of
the heat exchanger.
A
Panel heater wiring
B
Left rear pillar
C
Left frame
D
Plate rubber
E
Wire seal
* If the frame is not painted, place the supplied wire seal
around the hole
.
Hole
Tab
E
Left side
[Fig. 8.1.1.1]
<A>
A
C
B
[Fig. 8.1.1.2]
<A> Screw down the metal sheet wiring cover at three points.
A
Cover wiring 1
B
Cover wiring 2
C
Cover wiring 4
WT08867X01.book 12 ページ ２０１８年１月２２日 月曜日 午後３時１７分
