14
8
8.1.1
[Fig. 8.1.1.5]
<A>
<E, F>
<C>
<B>
*
2
E
D
G
*
1
C
B
A
A
A
A
A
F
Right rear side
Left rear side
Right rear side Left rear side
<D> Right rear side
Left rear side
<A> Pull up the panel heater wirings so that the wirings run along each pillar.
<B> Thread the panel heater wirings through the long hole on the right rear pillar.
<C> Run the panel heater wirings between the left rear pillar and the heat exchanger.
<D> Pull the wirings from the end of the heat exchanger and bring them into the
inner side of the heat exchanger.
<E> Attach the rubber sheet to the left frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a
reference position)
<F> Thread the wirings through the hole on the left frame, and bring them into the
inner side of the heat exchanger.
A
Panel heater wiring
B
Right rear pillar
C
Left rear pillar
D
Right frame
E
Left frame
F
Plate rubber
G
Heat exchanger fixing
plate
H
Wire seal
*1 If the wiring comes in contact with the edges of the heat exchanger fixing plate,
place the supplied wire seal.
*2 If the frame is not painted, place the supplied wire
seal around the hole
.
Hole
Tab
H
Left rear side
<A>
A
C
A
B
[Fig. 8.1.1.6]
<A> Screw down the metal sheet wiring covers at three points.
A
Cover wiring 1
B
Cover wiring 2
C
Cover wiring 3
WT08867X01.book 14 ページ ２０１８年１月２２日 月曜日 午後３時１７分
