MITS Eleven Auto FPZ-31AT, Command Manual, Page: 69 / 108

68
Start Job (Routing)
Click the Start Job icon.
And then select Routing (Btm) in the Milling Sequence Settings screen.
Click OK.
When Board Top / Bottom Change screen appears, click Adjust to check for milling speed.
On the Manual Operation screen, be absolutely sure to check the milling speed.
If this speed is too high, it could cause the tool to break.
Close the Manual Operation screen and click OK on the Board Top/Bottom Change screen to
begin routing.
When the drawings have the inside routing data, it is
good to separate the tool No. for inside and outside.
And also, tool No. for inside should be smaller
than one for outside because contour routing
will process smaller tool No. first.
Please refer Converter and EasyCAD manual
for how to generate routing data.
When routing inside data, the depth of cut is same as drill.