MITS Eleven Auto FPZ-31AT, Command Manual, Page: 108 / 108

107
Recovery of Auto Tool Change
If a problem occurred during the previous session and milling had to be stopped
or the power was turned off by mistake or some other unusual event occurred,
please do the following procedures for recovery. Otherwise, it may cause the
unexpected action.
Recovery after Accidental Stop
Call up the manual operation screen and click ATC button.
The screen illustrated below will appear.
1. In the case that tool change failed in the previous session, the
screen shows -1 in the tool No. field.
This means that software is unaware of the tool that the machine is currently holding.
2. In field Put back to, enter the No. of the tool post which the prototyping machine
actually has. Be sure that the actual tool post is empty which is specified as Put back
to.
3. Enter a different tool No. in field [Get for].
4. Click OK, and the spindle head returns the tool it is holding to the tool post
Put back to.
And the spindle head picks up the tool from the post Get for.
5. Now software knows what tool is held.