MITS Eleven Auto FPZ-31AT, Command Manual, Page: 45 / 108

44
Manual Operation
In this section, you will learn how to operate manual operation. When fabricating a PCB,
the operation is done automatically. However, there are times where manual operation
(operate the machine manually) will be used for precision.
WARNING: Do not set a tool bit in tool post number 10. Normally the machine is
holding dummy tool before shipment and tool post number 10 is for the dummy tool.
Use post number 1 through 9 only.
Connect the prototyping machine and the computer and launch CAM-Z under the
application. Close the cabinet and check the emergency switch is off. Turn the power on
and the machine will activate and move to the initial position (the spindle head will move
initial position of the machine).
(If it does not move to the initial position, check is the emergency switch or the interlock is
on.)
Click on the Manual Operation icon.
The spindle head will move forward (to the P1 point), and manual operation window will
open.