MITS Eleven Auto FPZ-31AT, Command Manual, Page: 38 / 108

37
Set P3
You will now set P3 point, which is a front point of the registration point.
Click on Manual Operation icon.
Move the head to the desired P3
location using the manual operation
screen.
You may move down the spindle
head by clicking DOWN button.
It is easier to see the location when the
spindle head is down.
Click Set P3 temporarily to register the P3 location to the software.
In order to check if the registration pin in the back would be in the working area of the
prototyping machine, move the head backwards 190mm from the P3 point.
Input 190 for Move distance and click BACK.
If P3 location is necessary to re-adjust, move the spindle head to the
desired location and then click Set P3 again.
If you encounter the hard limit error, click To Initial on the manual operation screen.
It will retrieve the current location of the spindle head. Otherwise, the software will
lose the position.
If you don't see Set P3 button in manual operation screen, close the screen and go
to CAM Prefs.
→
Board Maker screen. Set Reference hole to P1-P2 Revised
and try again.