MITS Eleven Auto FPZ-31AT, Command Manual, Page: 62 / 108

61
Adjust Depth of Cut
Make a test cut to check the width of the channel cut by the milling cutter. Change the tool
to milling bit.
First, turn the adjustment screw enough to make
the milling bit shallower and not touch the surface
of the board.
Move the spindle head to the outside of P1-P2 milling area.
(using the directional buttons as needed)
Turn ON the spindle motor.
Click DOWN to lower the head.
Turn the depth adjustment screw deeper until the
tip of bit touches the surface of board.
In this position, press one of the directional
buttons once and a trial cut will be made.
Click “UP” to raise the spindle head.
Turn OFF the spindle motor.
Move the spindle head to the position where you can check the result of cut. Check
the width of the channel that was cut.
Adjust the milling cutter depth and make trial cut several times until the width of this channel
is the same as the diameter of the tool specified in EASYCAD or the Converter program for
milling outlines.