MITS Eleven Auto FPZ-31AT, Command Manual, Page: 54 / 108

53
Make Hole for Registration Pin on Board
When processing double-sided board, the holes for the
registration pins are necessary on the board.
Change the tool to 3mm drill.
When the depth screw is adjusted correct position with the milling bit which is 2mm shorter
than the drill bit, the 3mm drill bit is 2mm out of the pressure foot.
Click P3 to move the head on p3 point.
To drill a hole to the board, move the spindle head to the P3 point, click spindle ON and
then click DOWN to lower the spindle head.
Click UP to raise the head, move 190 mm backwards and drill the hole. Insert the registration
pin into the hole.
You may also insert registration pin when milling top side is finished in order to align
bottom side.