5330e/5340e IP Phones – User Guide
Call Forward - Override
To override Call Forward and ring a station:
1. Lift the handset.
2. Dial the appropriate feature access code.
3. Dial the extension number.
Call Park
The Call Park feature allows you to place a call in a special hold state. You, or someone else,
can then retrieve the call from any extension in the system.
After parking the call, the system can automatically connect you to paging equipment so that
you can announce the call to the requested party.
To park an active call:
1. Do one of the following:
Press
the
Call Park
feature key (must be programmed)
Press
(
TRANS/CONF
), and then dial the appropriate feature access code. The
display shows PARKED@, followed by the park destination and parking spot index (if
applicable). Example: PARKED@ 1234 @ 02.
2. Dial the directory number on which to park the call (not required if the number is
programmed to the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
If automatic paging is enabled, announce the call and the park retrieve digits shown
on the display.
If automatic paging is disabled, press the programmed
Page
key, or dial the
appropriate feature access code, followed by the Paging zone number (if required).
Then, announce the call and park retrieve digits shown on the display.
Note
: Paging over a loudspeaker is not permitted in handsfree mode; you must use the
handset or headset.
To retrieve a parked call:
1. Do one of the following:
Dial the appropriate feature access code.
Press
the
Call Park - Retrieve
feature key (must be programmed).
2. Dial the directory number on which the call is parked (not required if the number is
programmed to the Call Park feature key).
- 37 -