![background image](http://html1.mh-extra.com/html/mircom/fa-300-6l-series/fa-300-6l-series_installation-and-operation-manual_1805759039.webp)
FA-300-6L Installation and Operation Manual
33
Entering the Passcode
The programming section is passcode protected. The following screen shows the message that is displayed to
enter the passcode. The maximum allowable passcode is ten digits long, and permits numerical values only. Press
the
(Enter button) key after entering the passcode. If the passcode is right, it will take you to the main
command menu. If the passcode is wrong the system will ask you to re-enter passcode. The system will be
exhausted after three retries and will then take you back to the Normal message display. The default password is
“1111” (without quotes).
Command Menu
The main command menu is pictured below. The first line of the LCD will always show
“-Command Menu-“, and the second line scrolls through different selections. Use the “UP” and “DOWN” keys to
scroll through the menu, and press
to make a selection. To exit from the main command menu, select the
“Exit” menu option and then press either
or
.
Note:
Command Menu features 1 and 9 can only be accessed if jumper JW6 is placed on the main board,
see Table 1.
Enter passcode:
_
X
-Command Menu-
1. Panel Config
2. Config Info
3. Set Time
4. Set Password
5. View Event Log
6. Clear Event Log
7. Walk Test
9. Dialer Config
10. Test Dialer
11. Exit
8. i3 Loop Test