17
9.0
Keypad Configuration & Operation
The following shows the configuration at the DTC-300A using the keypad and the CFG-300
Configuration Tool. The Mircom Digital Communicator is configured by connecting the cable of
the
CFG-300 Configuration Tool
to the U18 connector on the DTC-300A Main Board and
placing the LCD over the 3 standoffs as shown in Figure 2.
In order to configure the DTC-300A, place a jumper on JW2, remove once configuration is
complete otherwise there will be a trouble.
To access configuration mode press the Menu button on the keypad
. The CFG-300 LCD
will display the Main Menu. The keypad on the DTC-300A board and the CFG-300 is shown
together in Figure 7
,
below.
Figure 7
DTC-300A Configuration
9.1
Entering the Passcode
The programming section is passcode protected. The following image shows the message
that is displayed to enter the passcode. The minimum number of digits allowed is four and the
maximum allowable passcode is ten digits long; numerical values only. Press the “ENTER”
key after entering the passcode. If the passcode is correct, it will take you to the main
command menu. If the passcode is incorrect, the system will ask you to re-enter the passcode.
The system will be exhausted after three retries and will then take you back to the Normal
message display. The default password is 1111
1
*
5
8
0
#
ENTER
MENU
CANCEL
INFO
6
2
ABC
3
DEF
4
GHI
JKL
MNO
7
PRS
TUV
9
WXY
QZ
#/--/.
42/5",%
'2/5.$
&!5,4
#05
&!),
,).%
,).%
0/7%2
/.
SYSTEM NORMAL
18:01 MON 2003-04-05
S/DTC-300A Idle
20:00 SUN 2006-10-1
E n t e r p a s s c o d e
_
Summary of Contents for DTC-300A
Page 2: ......