BPS-1100 Installation and Operation Manual
7
5.0 Modules Mounting Locations
The Main Chassis in a BPS-1100 enclosure comes pre-assembled with all power supply, main panel, and display
components and boards. Signal Adder Modules are installed from right to left using the supplied stand-offs, as
shown in the figure below, with the first Module plugging its 26 pin ribbon cable into P5 on the Main BPS-1100
Board, and using the included MD-579 four wire power cable as described in the Module Settings section. A second
Signal Adder Module would connect by plugging its 26 pin cable into the matching socket on the previous module to
the right, and by installing the supplied MD-579 four wire power cable as described in the appropriate Module
Settings section.
To enable communication from the Main BPS-1100 Board to all of the Circuit Adder Modules, it is necessary to
remove the Continuity Jumper on JW6 (near P5, the Signal Adder Module Connector) on the Main BPS-1100
Board. This jumper plug must be installed on the Continuity Jumper on the last installed Signal Adder Module (see
the appropriate Module Settings section to verify the location of the Continuity Jumper on a particular Signal Adder
Module). Only the LAST Signal Adder Module should have a jumper plug on its Continuity Jumper; all others must
be left without a jumper plug.
There needs to be enough Display Points for each circuit on an Adder Module, and these are assigned during
Configuration (see System Configuration Section) in the order in which the Adders are electrically installed (the
order in which they have their cables connected to each other). Both the number of points available for each Display
Type, and the number required for each Circuit Adder Module Type are described in the Module Settings Section.
Figure 3: Module Mounting Locations
Notes:
1. Front plate is not shown.
2. Adder modules may be:
A) Model SGM-1004A
B) Model RM-1008A