BJ-214
BJ Enabler Alarm
User guide
www.bjliveat.com
The BJ Enabler Alarm allows activating an emergency
alert. To activate the alarm you can use a switch or a
BJ System controller. This device uses radio
frequency signals.
It is possible to choose from 4 different signal tones
and plug an appliance into the socket. The appliance
does not depend on the Enabler’s status.
Fig.1: BJ Enabler Alarm
A) Using BJ System remote controllers
To activate remotely the alarm using the BJ System
controllers follow these steps:
1.
Select a position on the Enabler’s “RF code
selector” (Figure 1). The code assigned to the
Enabler is given by Table 1. A different melody
is assigned to each selector position.
2.
Connect the enabler to the mains, taking into
account the device’s technical characteristics.
3.
Program on the controller the RF code assigned
in step 1 (check the controller’s User Guide to
carry out this operation).
4.
Press the button on the controller to activate
the alarm. Once it is activated, the beep will
sound for a few seconds.
Table 1
Activating various enablers at the same time:
It is possible to activate various Enablers located in
different places at the same time by adjusting the
“RF code selector” to the same position in all of
them.
Activating different enablers:
It is possible to activated different Enablers by
pressing a different button on the BJ System
controller. You just need to adjust a different position
on the “RF code selector” in each Enabler.
Power supply
230~ / 50Hz
Maximum power supply
250V~
RF working frequency
433 MHz
Dimensions
105x59x50 mm
Socket for 3.5-mm mono female jack switch
Selector
0
1
2
3
4 to 9
RF Code
25
26
27
28
-
Function
Tone 1 Tone 2 Tone 3 Tone 4 Not used
1. Description of the device
2. Technical data
3. Operating instructions
IMPORTANT
:
Whenever the position of the “RF code
selector” is modified to assign a different code
to the Enabler, it must be unplug from the
mains socket for at least
5 seconds
. The new
code will be recorded when the Enabler is plug
again.
Switch
input
RF Code selector
Mains plug
Socket
Sound output
