![background image](http://html1.mh-extra.com/html/mircom/bps-1100/bps-1100_installation-and-operation-manual_1805853017.webp)
BPS-1100 Installation and Operation Manual
11
6.3 Signal Adder Module (Model SGM-1004A)
P2
Data Cable to P5 of Main BPS-1100 Module or to previous Adder Module.
P1
Data Connector for next Adder Module.
P4
Power Connector to P6 of Main BPS-1100 Module or to previous Adder Module.
P3
Power Connector for next Adder Module.
JW1
Continuity Jumper removed if there are any more Adder Modules installed.
JW2
Leave Jumper as packed for this BPS-1100.
JW3
Leave Jumper as packed for this BPS-1100.
JW4
Leave Jumper as packed for this BPS-1100.
JW5
Leave Jumper as packed for this BPS-1100.
J11
NOT USED for BPS-1100.
Jumper JW6 on the Main BPS-1100 Module must be removed if there are any Adder Modules installed.
Components
There are 4 green LEDs on the board, one for each signal zone. The LED will illuminate or flash following the signal
rate sent to its zone. It will be off when the system is normal and they will illuminate when a signal zone is activated.
The LED does not reflect what is happening on the signal zone, just that it is receiving data to activate that signal
zone. Jumpers JW2, JW3, JW4 and JW5 are positioned on pins 2 and 3 (right two pins with board orientation as
shown above) from factory. Leave as is for BPS-1100.
Figure 7: Signal Adder Module
Note:
The SGM-1004A requires 4 display points.