9.0 Indicators, Controls, & Operation
20
9.0 Indicators, Controls, & Operation
Refer to the following LED Indicators and Control Buttons and Switches locations.
Figure 14: Indicators and Control Location
The Main Display Panel on the BPS-1100 Signal Booster Power Supply consists of the following.
LED Indicators may be Amber, Red, or Green, and may illuminate continuously (steady), or at one of two Flash
Rates.
7 common LED Indicators
Test/Config, Common Trouble, A.C. ON, Reset, Lamp Test, Battery Trouble and
Ground Fault.
2 Common Buttons
Reset and Lamp Test
2 Configuration Buttons
Select and Confirm
2 Configuration LED Indicators
Select and Confirm
8 Input Indicators
1 red and 1 amber per each Input Zone 1 to 4.
20 Output Indicators:
1 amber LED per each Output Zone 1 to 20.
20 Output (O/P) Disconnect DIP
Switches
1 DIP switch for each Output Zone 1 to 20.
Configuration DIP Switch
(marked CONFIG.)
8 DIP switches for programming.
Fast Flash
120 flashes per minute, 50% duty cycle
Trouble Flash
20 flashes per minute, 50% duty cycle