2
2-15
Network Setup options
TCP/IP Setup options
N
OTE
:
Simultaneous operation of the Pi5500 on both an Ethernet and a Token Ring
network is not supported.
When you set an IP address, subnet mask, or gateway address for the Pi5500 during
Setup, you can allow the Pi5500 to get these addresses automatically from a DHCP,
BOOTP, or RARP server. First, turn on or restart the Pi5500 and allow it to reach
Idle. Next, make sure the DHCP, BOOTP, or RARP server is running. Finally,
perform Pi5500 Setup.
To configure the Pi5500 for TCP/IP, choose TCP/IP Setup.
Enter the appropriate settings for the network type you use (Ethernet or Token Ring).
Token Ring Setup appears as an option only if you have enabled Token Ring in Port
Setup.
For information about setting up printing with TCP/IP, see Chapter 4.
Enter the appropriate settings for Ethernet.
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
TCP/IP Setup
