MIMAKI tx300p, Operation Manual, Page: 61 / 130

3-3
1
2
3
4
5
6
Chapter 3 Setup
SETUP MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : LOGICAL SEEK/ Overprint/ DRYING TIME/ MARGIN (LEFT and RIGHT)/ FEED SPEED
• When you operate the machine according to the contents specified with the RIP software, set each
• item to “Host” when registering this machine type. When you set it other than “Host”, the machine operates according to
the machine setup.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value
When no instruc-
tion from RIP
exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority to the setting value at
the machine side.
Outline
FEED COMP. ( P.3-6) -9999 to 0 to 9999
Used to print a pattern for correcting a media-
feeding rate and correct it.
DROP.POScorrect ( P.3-7) -40.0 to 0 to 40.0
Used to adjust the dot position in go and return
printing.
LOGICAL SEEK ( P.3-7) HOST/ON / OFF OFF Sets the scan movable area during printing.
Overprint ( P.3-7) HOST/ 1 to 9 OFF
Sets the number of layers in which ink is to be
applied.
DRYING TIME
(
P.3-8)
SCAN HOST/ 0.0 to 9.9 sec 0 sec
Sets the time to wait for ink drying.
PRINT END HOST/ 0 to 120 min 0 min
MARGIN/LEFT ( P.3-8)
HOST/ -10 to 85mm
0 mm Sets a non-printing area along the right and left
edges of the media.
MARGIN/RIGHT ( P.3-8) 0 mm
FEED SPEED
*2
( P.3-9)
*2. When you set this to “100%” or more, required time for completion of printing will be shortened. However, enough drying time cannot be ensured and it may
affect the image quality.
HOST/ 10 to 200% 100 % Changes the media feeding speed in printing.
MAPS4
(
P.3-9)
AUTO
Perform setting to reduce stripes between passes.
MANU
AL
Pattern 1 / 2 / 3
Smoothing
Lv.
5 to 25 to 100%
AUTO
CLEANING
(
P.3-10)
DEFAULT, FILE,
LENGTH, TIME
Sets the automatic cleaning operation for the head
performed before printing or during printing.
DEFAULT
The value differs depending
on the type of ink to be used
and the operating
environment.
FILE INTERVAL 1 to 1000
TYPE NORMAL/ SOFT/ HARD
LENGTH INTERVAL 0.1 to100.0m
TYPE NORMAL/ SOFT/ HARD
TIME INTERVAL 10 to 480 min
TYPE NORMAL/ SOFT/ HARD
Cleaning Check ON/ OFF
Set to run or not a nozzle check after auto
cleaning.
EXEC.TIMING END OF FILE/PRINTING
Sets the timing for cleaning operation performed
when “LENGTH” or “TIME” is selected.
INTERVAL WIPING ( P.3-11) 3 to 255 min, OFF
Sets the wiping operation performed after printing
is completed.
RESET SETTING ( P.3-5) The configulation in the settings 1-4 can be reset ondividually.