MIMAKI tx300p, Operation Manual, Page: 117 / 130

5-9
1
2
2
2
5
6
Chapter5 Troubleshooting
Unable to print with the printing condi-
tions of the print data received.
• Check the output conditions of the print data
in the RIP software.
• Check the profile.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred in the communication
of USB.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error occurred during the access to
the printing condition data.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of
the X motor was detected.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
An error due to an excessive current of
the Y motor was detected.
Error in the take-up tension bar.
• The tension bar origin could not be
found.
• No change could be seen in the ten-
sion bar angle.
• Check the set state of the media.
• Make sure that the media can be wound
using the manual SW. Also, make sure that
the tension bar rises.
If it does not rise, adjust the counterweight.
(
P.2-20, P.2-20)
A problem has occurred in the take-up
tension bar.
• The tension bar control position has
deviated from the lowest point for a
certain period.
Limit position of the take-up tension bar
has been detected.
• The tension bar control position has
deviated from the highest point for a
certain period.
Roller sensor abnormality
• The roller sensor cannot be correctly
read.
• Confirm that the take-up unit of machine
setup and take-up tension bar setting are
ON. (
P.2-4)
• Check the set state of the media.
• Confirm that the winding unit operates using
the manual SW.
Message Cause Solution
ERROR 206
PRINTING MODE
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
ERROR 307
MCFD File IF Error
ERROR 401
MOTOR X
ERROR 402
MOTOR Y
ERROR 403
X CURRENT
ERROR 404
Y CURRENT
ERROR 423
TAKE-UP TENSION-BAR
ERROR 425
Take-UP WRONG
ERROR 429
Take-UP LimitDETECT
ERROR 44f
Take-UP Roll Sns Err