MIMAKI tx300p, Operation Manual, Page: 54 / 130

2-24
Chapter 2 Basic Operation
Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor printing.
Flow of media feeding correction
Perform media feeding correction as below:
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When printing with a take-up device, set the media first and then perform media correction.
1
2
3
Make the torque of the tension
6
Print the correction pattern.
If correction by counter weight/
torque adjustment is not
enough, input the correction
value in the feed correction
setting.
Referring to “Setting of Media Correction”
(
P.2-26).
Referring to “Setting the torque limiter”
(
P.2-25).
Referring to “Setting of Media Correction”
(
P.2-26).
Referring to “Setting of Media Correction”
(
P.2-26).
5
If correction by counter weight
adjustment is not enough,
adjust the torque. Referring to “Setting the torque limiter”
(
P.2-25).
Check that the feed correction
setting value is “0”.
4
Check the pattern and adjust
the counter weight of feeding/
take-up tension bar.
Referring to “How to adjust the weight of feeding/
take-up tension-bar” (
P.2-18).