MIMAKI JFX-1631/1615 Plus, Operation Manual

Page: 56 / 154

3-12
Setting the work change
Set whether to return to the local mode or keep the remote mode after online drawing.
(Supported from the firmware ver.2.70)
1
Press the key in the local mode.
2
Select the [SET UP] by pressing the or key.
v
3
Press the key.
4
Select the [WORK CHANGE] by pressing the or
key.
5
Press the key.
6
Pressing , select the work change setting
(OFF or ON).
• OFF : Keeps the remote mode after online drawing.
(draws next drawing data over a drawn face while receiving)
• ON : After online drawing, the Y bar moves to the view position set in advance ( P.2-13 “Evacuation
of Y-bar from the table”). When the Y bar moving has been completed, the machine returns to
LOCAL.
v
7
Press the key.
• When you set this to “OFF” in the Step 6, proceed to the Step 10.
8
Pressing , select the vacuum setting (OFF or
ON).
• OFF : After online drawing, turns off the vacuum and then returns to LOCAL.
• ON
: After online drawing, returns to LOCAL with the vacuum is ON.
v
9
Press the key.
10
Press the key several times to end the setting.
F UNC T I ON
V I EW
< EN T >
FUNCTION
F UNC T I ON
S E T UP
< EN T >
S E T UP
F E E D COMP .
< e n t >
ENTER
S E T UP
WORK CHA NGE < e n t >
S E T UP
WORK CHA NGE : OF F
ENTER
S E T UP
WORK CHA NGE : ON
S E T UP
V ACCUM
: ON
ENTER
SE T UP
VACCUM
: OF F
セッテイ
ワーク チェンシ ゛
: O N
ENTER
END