MIMAKI JFX-1631/1615 Plus, Operation Manual

Page: 124 / 154

5-2
Before taking a phenomenon as a trouble
If something is wrong with the device, the buzzer sounds and a corresponding error message is given on the
LCD. Take an appropriate corrective measure in accordance with the message.
The device cannot be energized
More often than not, this is due to improper connection of the power cable. Check that the
power cable has been properly connected to the power outlet and the computer.
The device cannot perform printing
This occurs when the data is not being transmitted to the device properly. It can also occur when any of the
device functions fails or the media has been set improperly.
Display [ WATER NOT READY ]
When [WATER NOT READY] appears on the display, the water temperature in the water heater has not reached
the predetermined value.
Has the power cable been connected to the
device and the receptacle?
Securely connect the power cable to them.
Is the correct interface cable used?
Use the USB2.0 interface cable.
Has the interface cable been securely
connected in position?
Securely connect the interface cable in position.
Yes
Is the message telling that ink has run out
shown on the display?
Replace the ink cartridge with a new one.
P.4-3
Printing is disabled before the temperature
reaches the predetermined value.
Wait until the temperature reaches the
predetermined value. When it has reached, the
message on the display disappears and printing is
enabled.
No
No
No
Yes
No