MIMAKI CG-130FXII, Operation Manual

Page: 40 / 152

– 2.10 –
CT2 020 080 0.30
CT2 050 080 0.30
CT2 050 080 0.30
CT2 050 100 0.30
CT2 050 080 0.30
CT2 050 080 0.35
CT2 050 080 0.35
• In the case where the pressure is smaller than 20 g, set the speed using a
10 cm/sec as a guide. If the speed is higher than the appropriate value, the
tool can rise to produce blurred characters or a portion that remains uncut.
• In case setting an over 1200mm width sheet, the maximum cutting speed is
limited up to 60cm/s to protect the sheet.( Even if the cutting speed is set to
60cm/s and above, the cutting speed is limited maximum at 60cm/s.)
• In case setting a cut line segment at 1000mm and above, the cutting speed
is limited maximum at 60cm/s.
Procedure
1) Press [TOOL] key to select the cut number.
Select [CT2].
2) Change the speed value with the jog keys [ ]
and [ ].
Increase the speed value to fast the speed. Decrease the
value to slow the speed.
3) Press [ENTER/HOLD] key or the jog key [ ] to
move the cursor to PRESSURE.
Press the jog key [ ] to return to the previous setting.
4) Change the PRESSURE value by pressing the
jog keys [ ] and [ ].
5) Move the cursor to the OFFSET by pressing
the [ENTER/HOLD] key or the jog key [ ] .
Press the jog key [ ] to return to the previous setting.
6) Change the OFFSET value by pressing the jog
keys [ ] and [ ].
7) Determine the setting values by pressing
[ENTER/HOLD] key or the jog key [ ] .