MIMAKI CG-130FXII, Operation Manual

Page: 44 / 152

– 2.14 –
Sheet detection
The width and length of the sheet is detected by pressing the arrow keys or [END] key in accordance
with the sheet loaded.
* Once the length of a sheet of media has been detected, if the received data
is larger than the sheet, only the portion of data that exceeds the sheet will
not be cut.
If the length of a sheet of media is not detected, the device will terminate
cutting operation at the time when data goes beyond the sheet.
* If the sheet sensor feature is set to the [OFF], a press on jog key [ ] [ ] [ ]
[ ] will cause the device to perform the same sheet detection as with the
case where the [END] key is pressed.
The setting direction of the media is rendered effective.
* The maximum length that can be detected at the front and rear ends of the
sheet of media is 3 m.
Method to detect a sheet
When a sheet of media is retained with the pinch rollers, the following two displays will appear
alternately on the LCD panel.
Press on jog key [ ] [ ] [ ] [ ], in accordance with the direction of the sheet loaded on the device.
ROLL < R > LEAF ROLL F LEAF
<
<
The position to
start detection
When detecting the rear end of the sheet
Max. 3 m
The origin after
the detection
The origin after
the detection
Max. 3 m
Front end of
the sheet Front end of
the sheet
When detecting the front end of the sheet
R set
Set a sheet from a rear side. F set
Set a sheet from a front side.