MIMAKI CG-130FXII, Operation Manual

Page: 109 / 152

– 3.57 –
4) Upon completion of the frame cutting, the
device will enter the local mode.
The display shown on the left will appear on the LCD panel.
* Do not raise the clamp lever while the LCD
panel gives the aforementioned display. If you
raise the clamp lever, the machine will terminate
cutting.
5) Establish a new origin.
Move on the sheet using the jog key (arrow key) to establish
an origin.
If the sheet has no space for cutting, replace the sheet with a
new one.
6) Press the [REMOTE] key to set the device in
the remote mode.
Feed the sheet by the maximum sheet length required by
data on cutting and start cutting.
If the sheet is not fed or the sheet is not sufficiently long,
replace the sheet with a larger one in the aforementioned
step 5) .
7) Carry out steps 5) and 6) in repetition.
Repeat those steps continuously until there is no data that
exceeds the sheet width.
Upon completion of those steps, the LCD display will give the
tool conditions.
CT1 020 050 0.30
CUT1 DIVISION
Adhesion
allowance
1cm