MIMAKI CG-130FXII, Operation Manual

Page: 30 / 152

– 1.14 –
Menu mode
There are the following four mode in this device.
Each of the four modes is explained below.
< NOT-READY > mode
This is the mode before the medium detector.
The keys other than the [REMOTE] key are effective.
< LOCAL > mode
This is the mode after the sheet detection.
All keys are effective to enable setups.
The device is able to receive data from computer, however, it will not perform cutting (plotting).
In this mode, it is possible to perform the following operations.
1. Pushing the appropriate [JOG] keys to detect a sheet and set up an origin.
2. Pushing the [TOOL] key to select a tool and set the configurations.
3. Pushing the [DATA CLEAR] key to erase the cutting (plotting) data the device has received.
4. Pushing the [FUNCTION] key to set cutting (plotting) conditions.
5. Pushing the [FEED] key to feed the sheet to be used.
< REMOTE > mode
The device cut(plots) an image from data it receives.
During the cutting (plotting) operation, push the [REMOTE] key to interrupt the cutting (plotting) opera-
tion.
< FUNCTION > mode
This is the mode in which cutting (plotting) conditions can be set.
While the device is in the LOCAL mode, push the [FUNCTION] key to put the device into the
FUNCTION mode.