Problem solving guide
80
Fault message at the end of a programme
Message
Cause and remedy
Align the machine
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
Check that the washer-dryer is aligned correctly as
described in “Installation - Levelling the machine”.
Check whether the maximum delivery height of
1.0 m has been exceeded.
If the fault message appears again, contact the Service
Department. The washer-dryer can still be used but
with reduced functionality.
Check load
There is no laundry in the drum.
The load is too small. The laundry is still damp be-
cause the residual moisture content in the laundry
could not be measured.
In future use a
Timed drying
programme for small
amounts of laundry.
The amount of laundry exceeded the max. load for
the selected programme.
Observe the maximum loads given in the Pro-
gramme chart.
"Rinse out fluff" Go
to "Further pro-
grammes" to start
this programme
The
Rinse out fluff
programme has not been used for
a long time.
Start the “Rinse out fluff” programme as described
in “Washing and Drying” - “Rinse out fluff”.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the
OK
sensor.
