Problem solving guide
79
Fault message at the end of a programme
Message
Cause and remedy
Check jet
The pumps are dirty.
Clean the pumps as described in “Problem solving
guide - Opening the door in the event of a blocked
drain outlet and/or power failure”.
Start the programme again after cleaning the
pumps.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Start the programme again after cleaning the jet.
If the fault message appears again, contact the Service
Department. The washer-dryer can still be used but
with reduced functionality.
Hygiene info
A programme using a temperature above 60 °C has
not been run for a long time.
In order to prevent bacteria and unpleasant odours
building up in the washer-dryer, run the
Mainten-
ance wash
programme using Miele machine
cleaner or powder detergent.
Check dosage
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing check the
dosage amount set.
Observe the instructions on the detergent pack-
aging and the degree of soiling of the laundry.
If necessary, reduce the dosage amount by incre-
ments of 10%.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the
OK
sensor.
