At the end of the Pyrolytic cleaning
programme
When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been released
– "Process finished" appears in the
display,
– a buzzer will sound if the buzzer is
switched on (see "Settings - Volume -
Buzzer tones"),
^
Switch the oven off.
The visual and acoustic signals are
switched off.
,
Danger of burning
Wait until the oven has cooled down
before removing residual soiling left
in the oven cavity from the Pyrolytic
cleaning programme.
^
The amount of soiling, e.g. ash, left in
the oven will vary depending on how
dirty the oven was to start with.
Most soiling can be easily removed
using a clean, damp microfibre cloth,
or with warm water and a little
washing-up liquid on a clean
sponge.
Depending on how dirty the oven
was there may be a visible layer of
soiling across the inner glass pane
on the door. This should be removed
using the scouring side of a
dishwashing sponge or with a
stainless steel spiral pad and a little
washing-up liquid.
^
When the oven has cooled down
completely after the Pyrolytic
cleaning programme, pull the
FlexiClip runners out to their full
extent several times.
Please note:
– The fibre glass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
If possible you should avoid trying to
clean it.
– After pyrolytic cleaning there may be
some discolouration or lightening to
the FlexiClip telescopic runners. This
will not affect the functioning of the
runners in any way.
– Spilt fruit juices may cause lasting
discolouration to enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.
Cleaning and care
116
Summary of Contents for Oven
Page 21: ...aOn Off sensor K bDisplay c I N sensors Oven controls 21 ...
Page 145: ...145 ...
Page 147: ...147 ...
Page 148: ...M Nr 09 610 280 00 en GB H6890BP ...
