MICROWELL DRY 300, Installation And User Manual

Page: 39 / 68

Installation and user manual D R Y 3 0 0 / 4 0 0 / 5 0 0 M e t a l / S i l v e r
V01/2022 | 3 9
Heat output of heating element LPHW (W)
DRY300/400 DRY500
90/70/30°C 3500
5000
80/60/30°C 3005 4200
70/50/30°C 2240 3350
55/45/30°C 1550 2150
45/35/30°C 665 1005
Water flow (l/min)
5.1 6
Pressure loss (kPa)
12.3 24.1
Water circuit
connection ½“ inner ½“ inner
5.6 Electric heating
On demand, your pool dehumidifier can be equipped with an
electric heater. It consists of a durable stainless steel tube in
aluminium heat exchanger. Capacity 2kW for DRY300/400/500.
The electric heater has a separate power connection, which is
locatedin the black box the dehumidifier connection to the
power supply located in the dehumidifier electrical box.
The electric heater is equipped with two safety switches.
The electric heating is switched on and off according to the set required air temperature on the
dehumidifier controller / digital built-in or wireless DRY EASY 300 /.
Please note that the outer cover of the dehumidifier is made of metal. In the upper part of this cover
during electric heating, its temperature can rise up to 65 ° C (at an air temperature of 35 ° C). It is
therefore forbidden to touch the metal cover at the top of the dehumidifier during operation of the
heater. It is also forbidden for children to play with or with the dehumidifier. Please note that
children should be supervised by an adult at all times in the room where the dehumidifier is installed.
El. connection of hot water heating element
El. heating element – power input El. heating element – power input El. heating element – power input
2 kW CYSY 2 x 2,5 mm 2 16 A
The device can be equipped with an IP44 power cable. Use an IP44 socket. A socket with a lower degree of
protection than IP44 does not guarantee the protection of the dehumidifier.
When using an IP44 power cord and outlet:
• Do not place the plug and socket in humid places or in places with leaking or dripping water.
•
Do not place any objects on the cable, do not use the cable for any purpose other than to power the
device.
• Place the cable away from other appliances such as radiators, motors, rotors, etc.
• Do not use a dehumidifier if the cord shows signs of damage.
•
Always observe the electrical requirements for installation / e.g. breaker.
•
Children and unauthorized persons must not manipulate the cable or plug.
It is recommended to insert a
shut-off valve between the
LPHW hot water insert and
the heating source. This will
allow it to be quickly
disconnected from the
heating system in the event of
a fault in the heating system
and maintenance of the
system or dehumidifier.