Microtronics myDatalogNANO, User Manual

Page: 72 / 132

Universal inputs
(PWM mode)
PWM Filter time Time in [ms] during which the signal must remain constant
to initiate a level change. Used to suppress brief faults
(debouncing).
Decay Temporal function in the measurement cycle
Off Decay deactivated
min The minimum of the last x measurement
values is recorded.
max The maximum of the last x measurement
values is recorded.
avg The arithmetic mean of the last x
measurement values is recorded.
med The median of the last x measurement values
is recorded.
rms The root mean square of the last x
measurement values is recorded.
Time Decay period. Up to a maximum of 60 measurement
values​can be used for the calculation (e.g. 1 channel:
60 measurement values; ... 4 channels: 15 measurement
values each). To calculate the number of measurement
values that are taken into account, refer to "Example to
clarify the record interval, measurement cycle and burst
interval in conjunction with the decay" in chapter "Basic
setting" on page 87.
Hold Hold the last valid measurement value for x measurement
cycles
Off Function deactivated
1-5 Number of measurement cycles for which the
measurement value is held until the error value
is issued
On In the event of an error, the last valid
measurement value is held until a new valid
measurement value is present.
Out of
range Procedure in the event of measurement range violations
Ignore The measurement value is calculated beyond
the range limits.
Silent cutoff The measurement value is truncated at the
range limits.
Out of
range
l
If the measurement value is below 1%,
the error value "UF" (underflow) is
issued.
l
The error value "OF" (overflow) is
issued, if the measurement value is
above 99%.
72 Rev. 02