Microtronics myDatalogNANO, User Manual

Page: 64 / 132

9.1.1.2 Status LED
The status LED is used both to display the error/status codes and to indicate the current operating state. If the
Aloha transmission mode was activated or the power supply was provided (PowerOn), the status LED shows
the current operating state for 10 minutes. During these 10 minutes, the error/status codes are issued every
3 seconds as long as there is no GPRS connection.
Flashing
code
Description Solution/cause
0x Transport lock (GPRS OFF, measurement
OFF) If the Aloha transmission mode is initiated by
solenoid switch, the myDatalogNANO
switches back into "RUN" mode (GPRS ON,
measurement ON).
1x Last connection OK ---
2x Last transmission faulty Try again later
4x Standby (GPRS ON, measurement OFF) see "transport lock"
6x Offline (GPRS OFF, measurement ON) see "transport lock"
7x Network block/no matching provider
l
Improve the position of the antenna
l
Check whether the device is located in
the coverage area of one of the service
providers supported by the integrated
SIM chip
(www.microtronics.com/footprint)
8x No GSM network
l
Try again later
l
Improve the position of the antenna
10x No GPRS connection Improve the position of the antenna
11x No myDatanet server available
l
Check whether port 51241 is enabled on
the myDatanet server
l
Try again later
12x Faulty SIM chip Contact support
Error/status codes
Status
LED
Description
Flickering Establishing connection
Lights up GPRS connection established or solenoid switchactuated
Off Normal measuring operation according to configuration until the next transmission
Operating states
64 Rev. 02