Microtronics myDatalogNANO, User Manual

Page: 19 / 132

Chapter 4 General specifications
4.8 Device labelling
The specifications in this user manual apply exclusively to the myDatalogNANO device type. The type plates
are located on the right side of the device and contain the following specifications:
l
Type designation
l
Item number
l
Manufacturer's address
l
Specification of the device range
l
Serial number
l
Environmental conditions during operation
l
Protection class
l
Country list profile of the SIM chip
l
Hardware revision
l
CE marking
The correct specification of the type designation and serial number is important for all queries and spare part
orders. Only then can we process requests promptly and properly.
Type plates myDatalogNANO
Note: This symbol indicates the country list profile (see www.microtronics.com/footprint) of the SIM chip
installed in the device.
Note: These operating instructions are part of the device and must be available to the user at all
times. The safety instructions contained therein must be observed.
DANGER:
It is strictly prohibited to disable the safety equipment or modify its mode of operation.
4.9 Installation of spare and wear parts
Be advised that spare and accessory parts that have not been supplied by the manufacturer have also not
been inspected or approved by the manufacturer. The installation and/or use of such products can possibly
have a negative impact on the specified constructional properties of the device. The manufacturer shall not be
liable for any damages that arise from the use of non-original parts and non-original accessory parts.
Rev. 02 19