Microtronics myDatalogNANO, User Manual

Page: 106 / 132

5. Complete the steps in reverse order to insert the new battery pack. During this process, ensure that the
connection cable of the negative pin of the battery pack (black cable) is between the battery pack and
retaining bracket.
6. Reconnect the connector of the battery pack to the supply connector of the device. Just like when the
connection was disconnected, avoid applying excessive force and insert the connector of the battery
pack as straight as possible into the supply connector.
Important note: Observe the polarity of the battery pack connector.
The following step is not mandatory.
7. Check whether the connection to the myDatanet functions correctly (see "Testing communication with
the device" on page 61).
8. Close the housing cover. The best option is to tighten the four screws crosswise (torque 0,5Nm) so that
the housing cover is positioned evenly.
Important note: Ensure that the seals are clean and intact before closing the housing cover.
Remove any impurities and/or dirt. The manufacturer shall not be liable for any damage to the
device caused by leaky or faulty seals.
9. Check that the housing cover is positioned correctly on all sides and that no foreign materials have
been trapped between the housing and housing cover.
Important note: The manufacturer is not liable for any damage that is caused by housing
covers that are not closed correctly.
106 Rev. 02