Microscan EZ Match, User Manual

Page: 24 / 431

1-12
EZ Match User’s Manual
Test Read Rate
Step 9 — Test Read Rate
Read Rate indicates the number of tube/cap detections or successful decodes per second
achieved by the imager.
Test Read Rate by EZ Button
1. To start the Read Rate test, hold
down the EZ Button about three
seconds until you hear
three
short beeps . The 20% , 40% , and
60% LEDs will illuminate.
While the object is being
inspected, the Read Rate LEDs
will indicate the corresponding
read rate percentage on the back
of the unit.
2. To end the Read Rate test, press the EZ Button and quickly release.
Test Read Rate by ESP
1. Click the Test button to start the Read Rate test and Stop to end it.
If a tube or cap has been successfully detected, or a symbol has been successfully
decoded, the object’s data and related features will be presented in the field below the
image display window. Also, while the object is being inspected, the Read Rate LEDs
will indicate the corresponding Read Rate percentage on the back of the unit.
2. To end the test, click the Stop button.
Note: Read Rate can also be tested using the Read Rate interface in Utilities .
Test Read Rate by Serial Command
You can also start a test with the <C> or <Cp> command and end it with the <J> command.
20%, 40%, 60%, 80%, 100% .
These LEDs represent the
percentage of Good Reads
per images captured.