MGI JETVARNISH 3DS, User Manual

Page: 69 / 176

JETVARNISH 3DS 8. How to use the machine
User Manual - 69 -
8.3 Margin table
8.3.1 Margin table presentation
[1] Margin table belt
[2] Left side lay
[3] Balls guide holding bar
[4] Balls guide
8.3.2 Side lays position adjustment
To put the substrate at the center of the printing belt. the substrate pile has to be also centering on the
feeder to be well vacuuming by the vacuum drum. Place the side lay to make the substrate enter at the
middle of this one.
According to the registration side of the substrate. use the corresponding side lay. Turn the margin belt
to make it move toward the used side lay.
Use the pick-up button to put the substrate at the entrance of the margin table belt [1]. Adjust the
position of the side lay to make the substrate enter at the middle of this one. use the position
adjustment handles at each end.
Otherwise if the skew is on the counter-clockwise direction. make the side lay turn the same.
8.3.3 Margin table error code
During use of margin table. these error codes can be displayed:

E562 - Motor board defect.

E572 - Paper jam.
[1] [2]
[3]
[4]