Metronix 9200-4104-2000, Mounting Instructions

Page: 16 / 95

2 For your own safety
2.10 Protection against contact with hot parts
Risk of burns due to hot surfaces
The servo drive and, in particular, the (external or internal) braking resistor may become
hot during operation. Always wait a sufficient amount of time prior to touching these
parts. Always use suitable personal protective equipment to avoid severe burns.
2.11 Protection during the handling and
installation of the devices
Risk of injury caused by crushing, shearing, cutting or impacts
Improper handling and installation of certain parts will cause injuries.
Always follow the safety instructions stated hereinbelow.
l
When installing the servo drive, ensure that it can be installed, operated and
removed without any danger.
l
Appropriate installation clearances must also be defined.
l
Comply with the intended use of the servo drive.
l
When transporting the servo drive, pay particular attention to the edges and corners
of housings and other components. Use suitable personal protective equipment.
l
If you install the components of the system on a wall or on the floor, dust may be
created by drilling. Use suitable personal protective equipment.
l
Use only suitable installation and transport equipment.
l
Prevent trapping and crushing by suitable protective measures.
l
Use only suitable tools. If specified, use special tools.
l
Use lifting equipment and tools in a proper manner.
l
Do not step under suspended loads.
l
Liquid spills on the floor must be removed immediately.
Mounting Instructions BL 4000-M and BL 4000-D Page 16 of 95