5 Electrical installation
Pin assignment: motor connector (HIPERFACE DSL
®
)
Figure 16: Pin assignment: „motor connector (HIPERFACE DSL
®
) [X6]“
Pin
Name
Specification
A
U
Motor phase U
B
V
Motor phase V
C
W
Motor phase W
PE
PE
Protective earth conductor of the motor
1
MT+
2
MT-/ DSL-
HIPERFACE DSL -
3
BR+
Holding brake +
4
BR-
Holding brake -
5
DSL+
HIPERFACE DSL +
Cable type and configuration [X6]
The cable names that are stated refer to cables made by Lapp. However, it is also
possible to use comparable cables from other manufacturers, for example Lütze or
Helukabel.
For fixed installation: LAPP KABEL ÖLFLEX SERVO 719 CY
For highly flexible use (drag chains): LAPP KABEL ÖLFLEX SERVO FD 796 CP
Device type Cable type
Specification (U, V, W, PE)
BL 4104-D
4 G 1,0 + 2 x (2 x 0,75) 4 x 1,0 mm² (AWG 18)
Comply with the required minimum cross-section
Always observe the minimum cross-sections for the lines U, V, W and PE according to
the above table. Comply also with the maximum permissible cable capacity as per
section 6.5
BL 4100-M / BL 4100-D: Motor connector [X6]
Mounting Instructions BL 4000-M and BL 4000-D
Page 41 of 95
Summary of Contents for 9200-4104-2000
