INSTRUCTION MANUAL
– BALER Z562
45
The hydraulic system
Problem
Possible cause
Solution
The rear cover will not close.
Closing of the rear cover
blocked by a bale.
Remove the bale.
The hydraulic hose
disconnected from the tractor.
Check the connection and
connect the hoses if necessary.
The throttle/ non-return valve
adjusted incorrectly.
Adjust the throttle/ non-return
valve according to Section 4.9.
The hydraulic system does not
work.
No supply of the hydraulic
outputs.
Activate the hydraulic outputs
from the tractor.
The hydraulic hoses are not
connected correctly to the
external sockets of the tractor
hydraulic circuit.
Check, and, if necessary,
carefully seal, the quick-fit
coupling of the external sockets
of the tractor hydraulic circuit.
Insufficient oil supply.
Check and, if necessary,
replenish, the oil in the
appropriate tank of the tractor
hydraulic system.
The pump worn out or
damaged (low pressure).
Repair or replace the hydraulic
pump.
Dirt inside the hydraulic circuit. Blow, and, if needed, clean, the
hydraulic filters.
Oil leak in the cylinders (oil
goes past the piston).
Replace the seals in the
cylinders.
Oil leaks from the hydraulic
system.
Check the hoses of the
hydraulic circuit and seal the
connections, if necessary.
The control panel
Problem
Possible cause
Solution
Despite the chamber
’s being
closed, the panel displays
“Open chamber”.
The sensor distance to the
lever adjusted incorrectly.
The sensor should be 2-3 mm
from the lever.