INSTRUCTION MANUAL
– BALER Z562
17
Throughout that time, the engine maintains the press devices in motion through the
rear PTOff. After the indicator B has returned to the home position, open the rolling chamber.
The control panel indicates the press cover opening by lighting the pictogram of the press
cover
’s lifting. The rolled bale rolls out to the ground along the collector and facilitates the
cover
’s closing and resuming the crop collection and swathe rolling.
After approximately four seconds from the closing of the chamber cover, release the
control lever of the tractor
’s hydraulic manifold to allow the correct clamping of the mechanical
locks protecting the chamber from unauthorised opening.
Prior to harvesting, the material must be properly prepared by raking. Subsequently,
form the windrows into strips not wider than 1.1 m in width. Collect the shaped windrow strips
as shown in the following diagram. Adjust the length of the straight sections to the particular
conditions. To prevent clogging the baler, the width and height of the windrows should be equal
throughout their lengths. Slow down at wider windrow sections.
Figure 27.
Windrow collection
Mow grass and other papilionaceae intended for ensilaging and wrapping in the first
phase of earing (preferably in the afternoon). Next day, after a few hours of drying, gather the
mowed material with the use of balers. Keep the highest-possible bale-compaction degree.
The recommended driving speed for the tractor is up to 10 km/h.