INSTRUCTION MANUAL
– BALER Z562
31
The measurement blade (13) location in the baler is shown in Figure 42. The
measurement blade, controlled by a revolving motion after slipping from the hub thread of the
belt wheel casing (12), makes the blade impact on the counterknife and cut off the binding net.
Figure 42.
The location of the measurement blade
4.13 Adjusting The Cover Stop Valve
Next to the hydraulic coupling (1), there is a throttle/non-return valve (2) enabling the
adjustment of the hatch closing action. The adjustment must be carried out as follows.
•
Lift the hatch
•
Loosen the locking nut (3), turn the valve (2)
•
Try to close the hatch
•
If the speed of hatch drop is sufficient, lock the valve (2) with the nut (3). If the drop in
speed is not sufficient, re-adjust the valve (2)
•
After the adjustment is finished, check that the hatch lock works correctly
Figure 43.
The cover-stop valve
Net cutting
Home position