44
INSTRUCTION MANUAL
– BALER Z562
Forming bales
Problem
Possible cause
Solution
Too-noisy a transmission.
Loose or unlubricated chains.
Lubricate the chains or adjust
their tensioners.
Bales are formed incorrectly or
havea conical shape.
Picking up the windrow mainly
on one side of the pick-up.
Drive the baler equally from
one side to the other.
The chain skips the teeth of the
toothed wheels.
Worn-out toothed wheels or
chain.
Replace the toothed wheels or
chain.
Loose chain.
Tension the loose chains.
Twine-binding
Problem
Possible cause
Solution
The twine was not bound, is
blocked, and is not gripped by
a bale.
Twine installation not according
to the diagram.
Install the twine according to
the diagram in Section 3.4.1.
Incorrect twine installation on
the belt wheel
Note the twine installation on
the belt wheel according to the
figure given in Section 3.4.1.
Too short a distance from the
loop to the roller.
Set the loop distance to ca. 25-
30 cm to the roller as
described in Section 3.4.1.
Twine-binding on the centre
section.
Loose twine between the box
and the belt wheel.
Tension the twine well between
the box and the belt wheel.
Too dense or too thin bale
twine-binding.
Unadjusted density of bale
binding.
Set the bale binding density
using the 3-step adjustment
device on the belt wheel.
Net-binding
Problem
Possible cause
Solution
The net is not distributed well
on bales.
Too large a mesh of the net.
Use a standard net.
Incorrect path of net flow.
Check that the net is installed
correctly.
The PTO shaft
Problem
Possible cause
Solution
Defective locking bolt.
Too big a bale diameter or
weight.
Decrease the bale diameter or
weight.