57
INSTALLATION INSTRUCTIONS
9.1.6 Pole Mount
Tube Support Installation Instructions
(1) Thread the metal strap through the rectangular holes on the corner support
(Figure 1).
(2) Use a Philips screwdriver to tighten the metal strap, and then line up the
holes on the water-proof box to the holes on the support. Use a hex driver to
secure in a clockwise direction (Figure 2).
(3) Installation completed (Figure 3).
Note:
When using water sealant, the entire portion of the spiral tooth of the
extension pole and the connector ring must be applied with the sealant. This
will prevent rain water leaking through the connection.
The holes on the wall support are of diameter φ 10 mm. Please use screws
of φ 8~9mm, and make sure the drilled holes are of correct size to ensure
proper installation.
Warning:
When using in an outdoor environment, the safety cable must be connected
to the main unit and safety wire screw hole. This will avoid personal hazards
if the unit falls from its installation.
Make sure there are no damaged parts during assembly.
Figure 1
Figure 2
Figure 3
A
Corner Mount
adapter
B
Metal strap
Summary of Contents for NIC910/930/950HPro
