Messoa NIC910/930/950HPro, Instruction Manual, Page: 12 / 68

12
OPERATION INSTRUCTIONS
6.Operation Instructions
Startup Screen
The startup screen will show the software version,
communication protocol, machine address, and trans-
mission baud rate etc.
6.1 Activate OSD Menu:
Method to activate the OSD menu may differ with the connected keypad
controller. For keypad controller that is compatible with Pelco P / Pelco D
(Messoa-P/Messoa-D), press the key to enter the main menu screen.
6.2 Horizontal Pan/Vertical Tilt:
Manual horizontal pan:
Manual horizontal pan must be controlled through the joystick on the keypad
controller. The rotation speed is adjustable between 0.1°~90°/sec by the
position of the joystick, and up to 150°/sec under Turbo mode. The speed will be
restricted when under Proportion P/T mode.
Manual vertical tilt:
Manual vertical tilt speed is adjustable between 0.1°~45°/sec, and the speed will
be restricted when under Proportion P/T mode.
Horizontal pan range 360° continuous rotation
Vertical tilt range 92°
Manual horizontal pan speed 0.1°~90° /s
Manual horizontal pan speed (Turbo mode,
Pelco P/Messoa-P only)
150° /s
Manual vertical tilt speed 0.1°~45°/s
Preset maximum rotation speed
Horizontal: 430° /s
Vertical: 200° /s
Note: for indoor environment, maximum tilt angle is 85 degree; maximum 92
degree for outdoor environment.
6.3 Scanning Mode:
6.3.1 Auto Scan:
Auto scan can be configured to run at startup, or can be controlled by the keypad
controller.
(a). When the scan range has not been set:
The camera will rotate horizontally until a command from the keypad controller is
VER:
PROTOCOL:
ADDRESS:
BAUD RATE: