Messoa NIC910/930/950HPro, Instruction Manual, Page: 48 / 68

48
INSTALLATION INSTRUCTIONS
9.1. 2 Wall Mount
Wall Hang Support Installation Instructions
(1) Remove the secure plate and drill 4 holes on the wall matching the mount
holes on the plate. Diameter φ3/8” (9.5mm), depth 1/1/2” (40mm).
(2) Hammer 4 screw mounts into the holes and then secure the plate with a hex
driver.
(3) Fasten the connector ring to the wall hang support in the clockwise direction
(Figure 2).
(4) Thread the cabling of the main unit through the short aluminum tube and
push the cables out from the bottom.
(5) Pull out the cables and connect the main unit to the connector ring in the
clockwise direction. Use hex driver to secure the stop screw to the connector
ring and fasten the safety cable to the tube (Figure 3).
(6) Installation completed (Figure 4).
Note:
When using water sealant, the entire portion of the spiral tooth for the
connector ring must be applied with the sealant. This will prevent rain water
leaking through the connection.
The holes on the wall support are of diameter φ 10 mm. Please use screws
of φ 8~9mm, and make sure the drilled holes are of correct size to ensure
proper installation.
When drilling the hole, please make sure the wall thickness is greater than
50mm in order to maintain its structural integrity.
Warning:
When using in an outdoor environment, the safety cable must be connected
to the main unit and wall mount bracket. This will avoid personal hazards if
the unit falls from its installation.When installing the main unit, please secure
the safety cable to one of the four screw holes on the nearby support frame.
Make sure there are no damaged parts during assembly.
Please remove the connector ring from the speed dome and replace with the
connector ring that comes with the support.
Figure 1 Figure 2