- 80 -
U.motion KNX Server Plus, Touch
Installation Manual
In the BASE mode the following settings are available:
NAME
Name of the SCENARIO inside the VISUALISATION
ICON
Graphical icon, through which the SCENARIO is displayed inside the VISUALISATION
VISIBLE
Defines whether the scenario should be visible or not within the visualisation
EXECUTE AT STARTUP
If enabled, the scenario will be started after the startup of the software.
NOTE: the execution takes place only after U.motion KNX Server Plus Touch has
terminated its internal function routines and controls, so after each reboot of the
device and also after a restart of the communication services.
By switching to EXPERT mode, the following additional options will be shown:
DESCRIPTION
Additional information that can simplify the search.
ITERATIONS
Number of repetitions. This number will indicate how often the SCENARIO will be
repeated. Normally, this parameter is set to "1"; if the scenario shall be repeated
several times, the desired repeat value can be configured here.
ENABLE ‘LEARN’-FUNCTION
With this function it is possible to save the state of the contained KNX objects. With
this function the end user can customize the scenarios for his needs, by setting the
system in the desired state and clicking on “UPDATE”.
STOPPABLE
If you activate this option, the SCENARIO can be stopped again after it has been
started; this only applies to scenarios with wait commands.
ENABLE PIN CONTROL
NEW PIN
REPEAT NEW PIN
Whit this option the room can be PIN-protected. To enable the PIN-protection the PIN
has to be inserted into the field “NEW PIN” and in “REPEAT NEW PIN”.
