- 42 -
U.motion KNX Server Plus, Touch
Installation Manual
In BASE mode the following options are available:
DELETE EXISTING KNX-OBJECTS
If this option is enabled, all KNX objects present in the database will be
deleted before the ETS-Import.
CREATE AUTOMATIC RELATIONS
This option enables / disables the automatic recognition of relations
between individual group addresses in the ETS-project and the creation of
the same relations in the U.motion KNX Server database, for example for
updating statuses of individual objects across multiple group addresses (e.g.
for central functions).
Enabling this option usually results in a correctly functioning and always
refreshed visualisation. If manual changes to the relations between KNX
objects and group addresses have been performed in the U.motion KNX
Server database, it is better to disable this option, otherwise all manual
changes will be overwritten. More details about modifying relations between
KNX objects and group addresses can be found in the following chapter.
SELECTIVE IMPORT
This option allows to select the single group addresses to import.
Note: This option is enabled automatically when the ETS-project to be
imported contains more group addresses than the license of U.motion KNX
Server allows.
The EXPERT mode shows additional options for the ETS import:
REMOVE NONEXISTING KNX OBJECTS
If this option is enabled, all previously imported KNX objects that aren’t
present in the new ETS project anymore will be deleted from the U.motion
KNX Server database.
REFRESH NAMES
REFRESH ETS FLAGS
If an existing U.motion KNX Server database is updated, two options define
whether the names and the read/write flags of the KNX objects within this
database should be adapted to the new names and flags from the ETS
project or not.
These options should not be enabled if there have been made changes on
KNX objects in the U.motion KNX Server database, independently from ETS
project
COMMUNICATION INTERFACE
The interface, through which U.motion KNX Server communicates with the
imported KNX group addresses, can be selected here. If no special
configurations in U.motion KNX Server have been made, only the integrated
KNX interface is available.
By clicking "NEXT" the import process is started, which will last a few minutes depending of the size of the ETS project to
import. U.motion KNX Server Plus Touch will automatically create the appropriate KNX objects which can be used to
create the graphical visualisation. Once the import process is finished, a summary of all actions is shown:
