- 126 -
U.motion KNX Server Plus, Touch
Installation Manual
15
R
EMOTE
A
CCESS
15.1
I
NTRODUCTION
This chapter explains how to configure the network for allowing remote access to U.motion KNX Server Plus Touch and
therefore be able to check out the VISUALISATION also from outside of the building.
15.2
R
EMOTE
A
CCESS THROUGH
I
NTERNET
To enable the remote access to U.motion KNX Server Plus Touch through internet, please follow the steps below:
●
The parameter “GATEWAY” in the network settings of U.motion KNX Server Plus Touch must be set to the IP
address of the installed internet router
●
The configuration of the installed internet router must be changed and a
Port-Forwarding
rule to the IP address
of the installed U.motion KNX Server Plus Touch on port 443 and 22 (data type ”TCP“) must be created.
If the ports 443 or 22 are already used for other remote accesses, then the port forwarding can be realized through other
ports, where the external ports must be forwarded to the IP address and the ports 443 and 22 of the installed
U.motion KNX Server Plus Touch.
Example: access through URL https://www.myUrl.com:1443
port 1443 of the internet router must be forwarded to the
IP address and port 443 of the installed U.motion KNX Server Plus Touch).
For detailed information on setting up a
Port Forwarding
rule, please refer to the documentation of the installed internet
router.
