Revised 08.2021
5-1
Operator’s Manual: 405 SLD Seed Express
™
Bulk Seed Tender
®
®
Section 5: TROUBLESHOOTING
In the following trouble shooting section, we have listed many of the problems, causes and solutions to
the problems which you may encounter.
If you encounter a problem that is difficult to solve, even after having read through this trouble shooting
section, please contact your authorized dealer, distributor or the factory. Before you call, please have
this Operator’s Manual and the serial number from your machine ready.
Problem
Possible Cause
Possible Solution
Engine will not start
No fuel
Fill the fuel tank
Low engine oil
Fill the crankcase with oil
Cold engine
Open choke
Ignition key switch off
Turn ignition key switch on
Battery dead
Recharge or replace battery
Engine problem
Refer to engine manual
Conveyor will not start
Not rotating
Start engine and increase speed above 1400 RPM
Drive pulley connection or conveyor coupling Repair or replace
Drive belt slipping
Increase belt tension
No hydraulic oil in reservoir
Check oil level
Electrical or hydraulic are not working properly
RC handset transmitter power is OFF
Turn power ON
Control panel power is OFF
Turn power ON
Battery cable or battery
Check battery cable and make sure battery is fully
charged
Error in the control system
Check LED Error Code light
Improper ground
Check for proper grounding electrical circuit
Hydraulic valve or motor
Ensure hydraulic pump is working properly and
hydraulic tank is filled with oil
Intermittent function
Check receiver antenna for damage and proper
connection. Loose connector at the valve coil
